入水：gate 進入位：　gate location 水口形式：gate type 大水口：edge gate
細水口： pin-point gate 水口大小：gate size 轉水口：　switching runner/gate
唧嘴口徑：　sprue diameter

二、流道: runner
熱流道：　hot runner,hot manifold 熱嘴冷流道: hot sprue/cold runner
唧嘴直流: direct sprue gate 圓形流道：round(full/half runner
流道電腦分析：mold flow analysis 流道平衡:runner balance
熱嘴：　hot sprue 熱流道板：hot manifold
發熱管：cartridge heater 探針: thermocouples
插頭：　connector plug 插座： connector socket
密封/封料： seal

三、運水：water line 喉塞：line lpug 喉管：tube
塑膠管：plastic tube 快速接頭：jiffy quick connector plug/socker

四、模具零件：　mold components

三板模：3-plate mold 二板模：2-plate mold
邊釘/導邊：leader pin/guide pin 邊司/導套：bushing/guide bushing
中托司：shoulder guide bushing 中托邊L：guide pin
頂針板：ejector retainner plate 托板：　support plate
螺絲： screw 管釘：dowel pin
開模槽：ply bar scot 內模管位：core/cavity inter-lock
頂針：　ejector pin 司筒：ejector sleeve
司筒針：ejector pin 推板：stripper plate
縮呵：movable core,return core core puller
扣機（尼龍拉勾）：nylon latch lock 斜頂：lifter
模胚（架）： mold base 上內模：cavity insert
下內模：core insert 行位（滑塊）： slide
鑲件：insert 壓座/斜雞：wedge
耐磨板/油板：wedge wear plate 壓條：plate
撐頭: support pillar 唧嘴： sprue bushing
擋板：stop plate 定位圈：locating ring
鎖扣：latch 扣雞：parting lock set
推桿：push bar 栓打螺絲：S.H.S.B
頂板：eracuretun 活動臂：lever arm
分流錐：spure sperader 水口司:bush
垃圾釘：stop pin 隔片：buffle
彈弓柱：spring rod 彈弓:die spring
中托司：ejector guide bush 中托邊：ejector guide pin
鑲針：pin 銷子：dowel pin
波子彈弓：ball catch